How to use 2 axis and 1 axis gimbals
Since firmware version v2.43 two-axis gimbals are officially supported by the STorM32 controller.
Some general points:
- The unused motor axis must be disabled, i.e. the corresponding Pitch Motor Usage, Roll Motor Usage or Yaw Motor Usage parameter in the [GUI:Setup] tab must be set to {{PARAMVALUE|disabled}.
- A 2nd IMU is not used, even if one is present. It can be disabled (Imu2 Configuration = “off”), or not, it doesn't matter.
The following articles host comments and setups of users dating from the days when the STorM32 didn't officially support 1- and 2-axis gimbals. They might be of interest nevertheless, especially the setups, so they are linked to here:
Pitch-Roll Gimbals
Please share your knowledge!
Different folk might have different settings which work for them. In order to explore the various solutions, I (OlliW) suggest that each of you add your solution in a separate chapter. Your addition should start with === This is My Name === as first line. THX.
Pan-Tilt Gimbals
Please share your knowledge!
Different folk might have different settings which work for them. In order to explore the various solutions, I (OlliW) suggest that each of you add your solution in a separate chapter. Your addition should start with === This is My Name === as first line. THX.