Where to get NT Modules

From STorM32-BGC Wiki
Jump to navigation Jump to search

Pre-assembled, ready-to-use NT modules became recently available commercially. Also, the widely available CC3D Atom can easily be converted into a NT IMU module by simply flashing the appropriate firmware.

Walmis0's NT IMU Module

These modules are based on a LPC1111 micro controller and use a MPU6050.

link to ebay shop:
http://www.ebay.com/itm/NEW-STORM32-NT-BUS-IMU-Module-MPU6050-/222087630402?hash=item33b5744e42:g:yAwAAOSw5L9XEMAv

CC3D Atom

The Open Pilot CC3D Atom can be used as NT IMU module, when flashed with the respective NT firmware. With the pin headers stripped off, it is also relatively small.

The Mini CC3D is even smaller, without the need of hardware modifications. Unfortunately it can be first-time flashed only via SWD, and a ST-Link programmer is additionally needed for converting it into a NT module.

Both boards are available cheaply from various Asian sources, and of course also at somewhat higher prices in many "regular" shops.

Some links:

Cables and Connectors

Unfortunately I don't know about a cheap and readily available source of suitable pre-configured cables with plugs. The 1 mm JST has however become kind of a standard in the RC world, and used for e.g. flight controllers, gimbal controllers, etc., which gives options.

Some options:

  • ReadyToFlyQuads/witespy: [1]. Explore the shop carefully and study the various options for configuration which are offered, with the right clicks it actually has some good deals.
  • Viacopter: [2]
  • Goodluckbuy: [3]. The silicon wires are not as flexible as for other imu module wires, but in lack of better options OK. Quite expensive.
  • Flyduino: [4]
Retrieved from "http:///storm32bgc-wiki/index.php?title=Where_to_get_NT_Modules&oldid=3533"