Using the DataDisplay

In combination with the [GUI:DashBoard], the [GUI:DataDisplay] is the main tool offered by the GUI for diagnosis and trouble shooting. It is also indispensable for tuning the gimbal.

1. State Field: Shows the current state of the controller. The possible states are described in Getting Started: First Startup.

2. Camera Angles: These fields show the current camera angles, as measured by Imu1, in units of degree.

3. Start/Stop: With this button the recording of the data is started and stopped.

4. Control Buttons:

[Clear]: Clears the internal data buffer and resets the DataDisplay.

[Save]: Allows to store the data which is in the data buffer into a file.

[Rec]: Activates the live-recording feature. On the first press, a dialog is opened which allows to select a data file name. Hence forth, all data which are recorded by the DataDisplay are immediately stored into the specified data file. The data are stored into the file for as long as the live-recording feature is activated. It is deactivated by pressing this button again.

5. Gravity Vector Plot: This plot displays the estimated gravity vector.

6. Input Values: These numbers represent the input values (see Inputs and Functions) for the functions (from top to bottom): Rc Pitch, Rc Roll, Rc Yaw, Pan Mode, IR Camera, Standby, Recenter Camera.

7. Angle Selector: With these checkboxes it is selected which values are shown in the angle plot. The checkboxes to the left refer to (from top to bottom): Imu1 Pitch Angle, Imu1 Roll Angle, Imu1 Yaw Angle. Next to them are the checkboxes to select (from top to bottom): Imu2 Pitch Angle, Imu2 Roll Angle, Imu2 Yaw Angle.

8. Angle Plot: This plot displays the angles as selected by the angle selector. The plot can be changed in size by changing the size of the [GUI:DataDisplay] window. Also the plot can be shifted up and down by moving the mouse cursor while pressing the left mouse button. The plot can be recentered vertically by pressing the right mouse button.

9. Zoom Buttons: With these buttons the displayed angle range is chosen.

10. Control Output Selector: With these checkboxes it is selected which axes are shown in the control output plot.

11. Control Output Plot: This plot displays the output of the PID controller, before the 2nd Imu corrections are applied (compare with NT Data Logging: Logged Data).

12. Battery Status: Shows the current battery voltage, and status.

13. Bus Error Status: Shows the current error count, since start of the gimbal controller.

14. Sensor Status: Shows the health status of Imu1 and Imu2.