Filters: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
Line 14: | Line 14: | ||
Currently, the following data sources are available: | Currently, the following data sources are available: | ||
* {{PARAMVALUE|off}}: The filter bank is inactive | * {{PARAMVALUE|off}}: The filter bank is inactive. | ||
* {{PARAMVALUE|gyro1 all}}: | |||
* {{PARAMVALUE|gyro1 x}}: | |||
* {{PARAMVALUE|gyro1 y}}: | |||
* {{PARAMVALUE|gyro1 z}}: | |||
* {{PARAMVALUE|imu1 all}}: | |||
* {{PARAMVALUE|imu1 x}}: | |||
* {{PARAMVALUE|imu1 y}}: | |||
* {{PARAMVALUE|imu1 z}}: | |||
* {{PARAMVALUE|mot all}}: | |||
* {{PARAMVALUE|mot pitch}}: | |||
* {{PARAMVALUE|mot roll}}: | |||
* {{PARAMVALUE|mot yaw}}: |
Revision as of 14:20, 18 October 2019
The information on this page refers to firmware v2.43e and higher.
The STorM32 provides a rich filter section to filter the gyro, accelerometer, encoder, and motor control data, using notch, band-cut, or low-pass filters.
The filters are organized into three identical filter banks, which are processed in series. That is, the data are feed into filter bank #1, the output of this bank is then feed into filter bank #2, and so on.
The parameters of the filter banks are exemplarily described for filter bank #1. They are
- Filter1 Source: Selects the filter source.
- Filter1 Center Frequency: Selects the center or cut-off frequency of the filter.
- Filter1 Bandwidth: Selects the bandwidth for notch or band-cut filters.
- Filter1 Attenuation: Selects the attenuation for notch or band-cut filters.
Currently, the following data sources are available:
- “off”: The filter bank is inactive.
- “gyro1 all”:
- “gyro1 x”:
- “gyro1 y”:
- “gyro1 z”:
- “imu1 all”:
- “imu1 x”:
- “imu1 y”:
- “imu1 z”:
- “mot all”:
- “mot pitch”:
- “mot roll”:
- “mot yaw”: