STorM32 Boards: Difference between revisions
No edit summary |
|||
Line 84: | Line 84: | ||
* motor current: 1.5 A<br/>'''''Comment''': The board uses the same motor drivers as the BaseCam SimpleBGC 32-bit board, and the same spec can hence be expected, but the real capability has not yet been tested in practice''. | * motor current: 1.5 A<br/>'''''Comment''': The board uses the same motor drivers as the BaseCam SimpleBGC 32-bit board, and the same spec can hence be expected, but the real capability has not yet been tested in practice''. | ||
* board dimensions: 50 mm x 50 mm, 45 mm bolt to bolt, holes Ø3 mm | * board dimensions: 50 mm x 50 mm, 45 mm bolt to bolt, holes Ø3 mm | ||
|} | |} | ||
=== Witespy STorM32 BGC Mosfet === | === Witespy STorM32 BGC Mosfet === |
Revision as of 16:48, 11 June 2015
The technical specifications of various STorM32 boards are presented. For suppliers/vendors please refer to Where to buy STorM32 boards. For a detailed description of the various connectors on the boards see Pins and Connectors.
"Original" STorM32 Boards
At present, the versions v1.1, v1.2, and v1.3 are in use (v0.17/v1.0 boards are deprecated). Their commonality is a resistive voltage regulator and the TC4452 motor drivers.
Comments:
- The boards can be populated with different motor drivers, namely TC4452 driver in DFN package or TC4452 driver in SOIC package; the DFN package allows somewhat higher motor currents.
- The boards can in principle be populated with different micro controllers; the standard configuration is a STM32F103RC.
STorM32-BGC v1.3
|
|
STorM32-BGC v1.2
Differences to the v1.3 board:
- voltage regulator: smaller SOT223 package
- only 2 auxiliary ports
STorM32-BGC v1.1
Differences to the v1.3 board:
- no Futaba S-bus support
- Spektrum satellite is supported, but no extra Spektrum connector on board
- no extra USB voltage protection diode
- voltage regulator: smaller SOT223 package
- only 2 auxiliary ports
WARNING: The pins of connector I2C#2 are in reverse order to those of connector I2C, which implies also reversed voltage polarity. Pay attention to that before connecting a second IMU to the I2C#2 port.
Descendants
The STorM32 boards listed here are based on/derived from the layout of the "original" board designed by Martinez and OlliW, but modified in some ways.
GLB STorM32 v1.31
|
|
Witespy STorM32 BGC Mosfet
|
|
Third-Party Boards
The terms of usage of the STorM32 project allows, and in fact encourages, making own hardware, for both DIY and commercial purposes, without restrictions.
GLB Mini STorM32 BGC
|
|
AliExpress Mini STorM32 BGC
|
|