Flashing the Mini CC3D Atom

From STorM32-BGC Wiki
Revision as of 08:02, 18 April 2016 by OlliW (talk | contribs) (→‎First-Time Flashing Using SWD)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

\:Atom Nano Top.jpg :Atom Nano Bot.jpg :Atom Nano case.jpg

On this board the BOOT0 pin is not exposed on a pad or solder joint, and even tied directly to GND, which makes any effort accessing it essentially impossible. The board however exposes the SWD pins as "O", "K", "-" and "+" pads. The simplest method for first-time flashing is thus to use SWD via a ST-Link V2 adapter, which is supported by the GUI. Any subsequent flashing (updating) can be performed using the simpler procedures described in Updating the Firmware of NT Modules.

First-Time Flashing Using SWD

1. You will need a ST-Link V2 programmer or similar. Ensure that it is working (drivers installed, etc.).

ST Link V2.jpg

2. Solder 3 wires to the "O", "K", and "-" pads on the Mini CC3D Atom and connect them to the programmer. There is a "+" solder pad very to close to the USB metal case. It is recommend to not use it but to power the board through its USB connector.

"O" to "SWDIO"
"K" to "SWCLK"
"-" to "GND"

3. Connect the ST-Link V2 programmer via its USB plug to the computer. When powered, the green LED on the Min CC3D Atom will be on, and after having booted the blue LED will flash with long on and short off periods. This indicates that the OP firmware is running. This matters since after flashing the NT firmware the on and off times of the blue LED are equal.

4. In the STorM32 GUI select the Flash Firmware Tab and set the fields as shown below (the [Board] field should be set to "NT Imu Module CC3D Atom" and the [Firmware Version] selected as desired):


5. Hit the Flash Firmware button, which will open a DOS window similar to below. The blue LED should now be flashing on and off with equal periods, indicating that the NT IMU firmware is running.

GUI Flash 4.jpg

Updating Firmware

For updating the NT firmware you may again use the just described method of using SWD/ST-Link, but also the "canonical" procedure described in Updating the Firmware of NT Modules.