STorM32 Boards: Difference between revisions
| Line 28: | Line 28: | ||
* 2 auxiliary ports (digital), BUT port | * 2 auxiliary ports (digital), BUT port | ||
| | | | ||
* supply voltage: 6 - 12 V or 2 - 3S (with motor drivers enabled) <br/>'''''Comment''': The motor drivers are enabled by closing the JP1 solder bridge on the bottom side of the board. When the solder bridge is open, the board can be used with voltages up to 20 V or 4S (??).'' | * supply voltage: 6 - 12 V or 2 - 3S (with motor drivers enabled) <br/>'''''Comment''': The motor drivers are enabled by closing the JP1 solder bridge on the bottom side of the board. When the solder bridge is open (motor drivers disabled), the board can be used with voltages up to 20 V or 4S (??).'' | ||
* motor current: 1.0 A (??) | * motor current: 1.0 A (??) | ||
* board dimensions: 40 mm x 28 mm, 35 mm bolt to bolt, holes Ø3 mm | * board dimensions: 40 mm x 28 mm, 35 mm bolt to bolt, holes Ø3 mm | ||
Revision as of 15:18, 17 November 2025
"Original" STorM32 Boards
At present, board versions v6.x are supported (v0.17/v1.0, v1.1, v1.2, v1.3x, v2.4, v3.3, v4.1 boards are not supported).
The STorM32 boards offer two types of NT bus ports, the NT and NT-X ports. They both are different from the NT bus connectors on the NT modules in that they have swapped Rx, Tx pins.
Comment: The Rx, Tx pins of the NT and NT-X ports on the STorM32 board must be connected to the Tx, Rx pins on the NT modules.
In addition to the boards shown here, also other variants exist, such as e.g. micro versions.
The design schemes are located in https://github.com/olliw42/storm32bgc
STorM32-BGC v6.3
|
|
Comment: This board is design of Gohstand Designs and based on the v4.1 design of KrattWorks.
STorM32-BGC v6.2
|
|
Comment: This board has no motor drivers; NT motor modules are thus mandatorily required.
