STorM32 Boards: Difference between revisions
| Line 34: | Line 34: | ||
* board dimensions: 40 mm x 28 mm, 35 mm bolt to bolt, holes Ø3 mm | * board dimensions: 40 mm x 28 mm, 35 mm bolt to bolt, holes Ø3 mm | ||
|} | |} | ||
{{COMMENT|This board is design of [https://www.gohstanddesigns.com/ Gohstand Designs] and based on the v4.1 design of [https://www.krattworks.com/ KrattWorks].}} | |||
=== STorM32-BGC v6.2 === | === STorM32-BGC v6.2 === | ||
Revision as of 15:17, 17 November 2025
"Original" STorM32 Boards
At present, board versions v6.x are supported (v0.17/v1.0, v1.1, v1.2, v1.3x, v2.4, v3.3, v4.1 boards are not supported).
The STorM32 boards offer two types of NT bus ports, the NT and NT-X ports. They both are different from the NT bus connectors on the NT modules in that they have swapped Rx, Tx pins.
Comment: The Rx, Tx pins of the NT and NT-X ports on the STorM32 board must be connected to the Tx, Rx pins on the NT modules.
Comment: The v6.2 STorM32 board has no motor drivers on-board, i.e., NT motor modules are needed in addition.
In addition to the boards shown here, also other variants exist, such as e.g. micro versions.
The design schemes are located in https://github.com/olliw42/storm32bgc
STorM32-BGC v6.3
|
|
Comment: This board is design of Gohstand Designs and based on the v4.1 design of KrattWorks.
STorM32-BGC v6.2
|
|
Comment: This board has no motor drivers; NT motor modules are thus mandatorily required.
