Dos and Don'ts - Revision history

OlliW: OlliW moved page Dos and Dont's to Dos and Don'ts

2015-01-08T18:53:42Z

OlliW moved page Dos and Dont's to Dos and Don'ts

← Older revision		Revision as of 20:53, 8 January 2015
(No difference)

OlliW at 09:11, 4 January 2015

2015-01-04T09:11:10Z

← Older revision		Revision as of 11:11, 4 January 2015
Line 3:		Line 3:
	This should have said it all, yet some specific don'ts:		This should have said it all, yet some specific don'ts:

	* {{WARNING\|'''~~Don't~~ get any parts of the board into contact with the (plus pole of the) battery'''}}, this will immediately destroy the board.		* {{WARNING\|'''Do not get any parts of the board into contact with the (plus pole of the) battery'''}}, this will immediately destroy the board.

	* {{WARNING\|'''The voltage on the POT and BUT pins must not exceed 3.3 V'''}}, else the board will be immediately destroyed.		* {{WARNING\|'''The voltage on the POT and BUT pins must not exceed 3.3 V'''}}, else the board will be immediately destroyed.

OlliW: OlliW moved page Dos and Donts to Dos and Dont's

2015-01-03T22:57:43Z

OlliW moved page Dos and Donts to Dos and Dont's

← Older revision		Revision as of 00:57, 4 January 2015
(No difference)

OlliW: Created page with "The STorM32-BGC is an electronic device. This should have said it all, yet some specific don'ts: * {{WARNING|'''Don't get any parts of the board into contact with the (plu..."

2015-01-03T22:56:16Z

Created page with "The STorM32-BGC is an electronic device. This should have said it all, yet some specific don'ts: * {{WARNING|'''Don't get any parts of the board into contact with the (plu..."

New page

The STorM32-BGC is an electronic device.

This should have said it all, yet some specific don'ts:

* {{WARNING|'''Don't get any parts of the board into contact with the (plus pole of the) battery'''}}, this will immediately destroy the board.

* {{WARNING|'''The voltage on the POT and BUT pins must not exceed 3.3 V'''}}, else the board will be immediately destroyed.

* {{WARNING|'''The voltage on any of the other pins must not exceed 5 V'''}}, else the board will be immediately destroyed.

* The 3.3 V pins on the board should only be used as supply. {{WARNING|'''Do not apply voltage to a 3.3 V pin'''}}. {{WARNING|'''Do not connect a 3.3 V pin to a GND pin'''}}.

* {{WARNING|'''Do not use metal screws to mount the board'''}}. This can lead to short circuits. At the very least use plastic washers.

* {{WARNING|'''Do not power anything from the 3.3 V power rail except of the intended items'''}} (camera IMU, 2nd IMU, Spektrum satellite, joystick, IR led).

* The motor drivers are not short-circuit protected. It is recommended for new/unknown motors to measure the resistances of the motor phases and to the motor housing before the they are connected to the board.