How to use 2 axis and 1 axis gimbals

From STorM32-BGC Wiki
Revision as of 21:14, 12 October 2019 by OlliW (talk | contribs)
Jump to navigation Jump to search

The information on this page refers to firmware v2.43e and higher.

Since firmware version v2.43 two- and one-axis gimbals are officially supported by the STorM32 controller, for both conventional and T-STorM32 (encodered) setups.

General

Some general points:

  • The unused motor axis must be disabled, i.e. the corresponding Pitch Motor Usage, Roll Motor Usage or Yaw Motor Usage parameter in the [GUI:Setup] tab must be set to “disabled”.
  • A 2nd IMU is not used, even if one is present. It can be disabled (Imu2 Configuration = “off”), or not, it doesn't matter.

The following articles host comments and setups of users dating from the days when the STorM32 didn't officially support 2- and 1-axis gimbals. They might be of interest nevertheless, especially the setups, so they are linked to here:

Pitch-Roll Gimbals

Please share your knowledge!

Different users might have different settings which work for them. In order to explore the various solutions, I (OlliW) suggest that each of you add your solution in a separate chapter. Your addition should start with === This is My Name === as first line. THX.

Pan-Tilt Gimbals

Please share your knowledge!

Different users might have different settings which work for them. In order to explore the various solutions, I (OlliW) suggest that each of you add your solution in a separate chapter. Your addition should start with === This is My Name === as first line. THX.

Roll-Only Gimbals

Please share your knowledge!

Different users might have different settings which work for them. In order to explore the various solutions, I (OlliW) suggest that each of you add your solution in a separate chapter. Your addition should start with === This is My Name === as first line. THX.