NT Pins and Connectors: Difference between revisions

From STorM32-BGC Wiki V1
Jump to navigation Jump to search
m (OlliW moved page NT Pinout to NT Pins and Connectors without leaving a redirect)
 
(10 intermediate revisions by the same user not shown)
Line 1: Line 1:
:[[File:NT_Pinout.jpg|640px]]
__TOC__
 
== STorM32 v1.x Boards ==
 
On the STorM32 v1.x main boards, the I2C plug is used a NT bus connector, with the pin assignments as shown below.
 
{{COMMENT|The Rx and Tx pins on the StorM32 board must be connected to the Tx and Rx pins on the NT modules.}}
 
:[[File:NT_Pinout.jpg|480px]]
 
== NT v1.x Modules ==
 
All NT v1.x modules have a 4 pin JST plug a NT bus connector, with the pin assignments as shown below. They in addition offer a BOOT0 solder jumper, to allow for a first-time flashing. Some modules offer some further solder jumper for configuring them, and some others expose also the SWD pins.
 
:[[File:Storm32-nt-imu-v10-docu-02.jpg|360px]]
 
== CC3D Atom ==
 
On the CC3D Atom boards the Main Port plug is used as NT bus connector, with the pin assignments as shown below.
 
:[[File:Storm32-nt-imu-cc3datom-docu-02.png|480px]]

Latest revision as of 12:16, 28 November 2015

STorM32 v1.x Boards

On the STorM32 v1.x main boards, the I2C plug is used a NT bus connector, with the pin assignments as shown below.

Comment: The Rx and Tx pins on the StorM32 board must be connected to the Tx and Rx pins on the NT modules.

NT Pinout.jpg

NT v1.x Modules

All NT v1.x modules have a 4 pin JST plug a NT bus connector, with the pin assignments as shown below. They in addition offer a BOOT0 solder jumper, to allow for a first-time flashing. Some modules offer some further solder jumper for configuring them, and some others expose also the SWD pins.

Storm32-nt-imu-v10-docu-02.jpg

CC3D Atom

On the CC3D Atom boards the Main Port plug is used as NT bus connector, with the pin assignments as shown below.

Storm32-nt-imu-cc3datom-docu-02.png