How to install and use a joystick: Difference between revisions

From STorM32-BGC Wiki V1
Jump to navigation Jump to search
(Created page with "'''This joystick solution is from irun4fundotca.''' Here's my joystick solution that wont break the bank (about $5-10usd). First off, its installed on a makeshift mount until...")
 
No edit summary
Line 6: Line 6:
   
   
Here's my connection drawing to make it simple using roll instead of pan as I don't have it connected on this one.
Here's my connection drawing to make it simple using roll instead of pan as I don't have it connected on this one.
[[File:Example.jpg]]
[http://www.rcgroups.com/forums/showpost.php?p=28055684&postcount=358 Joystick]

Revision as of 13:42, 12 April 2014

This joystick solution is from irun4fundotca.

Here's my joystick solution that wont break the bank (about $5-10usd). First off, its installed on a makeshift mount until I find a better one, due to selling my last one in frustration. It's a joystick sold on ebay for about $3.59usd with free shipping and comes with locking Molex. All that's needed is some wire, 3pin locking Molex housings, a 1-row 5-pin female Dupont header (to connect to POT pins GND,POT0,POT1,POT2,VCC).

All power on the joystick's ports is shared, so only one ground and vcc is needed. The other 3 wires provide the X(Roll- POT0), Y(Pitch-POT1), Z(button-POT2) signal.

Here's my connection drawing to make it simple using roll instead of pan as I don't have it connected on this one. Joystick